To inject Melanotan 2 you will need the following:
- 1 x 10ml Melanotan Vial Bottle (unmixed powder form)
- 1 x Injectable Water (for mixing with the MT2 vial)
- 1 x Alcohol Wipe (to clean injection area)
- 1 x New Insulin Syringe (1ml)
The most popular place to inject is on the stomach, alternating sides each time you inject in order to prevent the build-up of track marks and to ensure that the Melanotan 2 is evenly spread. Before you start clean your hands thoroughly with soap and warm water and dry your hands with a clean towel.
- Step 1
Tear open the alcohol wipe and carefully clean the area around where you are going to inject. Use the same wipe to clean the top of the Melanotan 2 vial.
- Step 2
Open the new insulin syringe (it is important that you use a new syringe every time), carefully remove the orange cap to expose the tip of the needle and then insert the needle into the middle of the rubber stopper on the Melanotan 2 vial. Turn the vial upside down and pull down on the plunger until you get your required dose using the scale on the side of the syringe. Do not exceed the standard recommended dose of 0.1ml (10 units) of Melanotan 2 and 1ml of water.
After you have filled the syringe with Melanotan 2 remove the needle from the vial and turn the syringe upside down (with the needle at the top). Flick the syringe with a finger a couple of times and to ensure that there are no bubbles trapped within the syringe and before injecting pull down the plunger a couple of millimeters and push it back up allowing a little of the Melanotan 2 to escape the needle to ensure that any air rises to the top and exits the needle, do not shake the syringe.
- Step 3
In the area of skin that you cleaned gently pinch a thin fold of skin at the injection site. The injection will be painless providing the pinched skin is kept thin. Slowly insert the needle into the skin at a 45 degree angle if you have a lean body type, or towards 90 degree the more that the body type is less lean.
Once the needle has been inserted below the skin use the index finger to slowly push the syringe’s plunger down until all the Melanotan 2 is injected. Once the plunger is pushed all the way down wait a few seconds before removing the needle to ensure that all the Melanotan 2 has been injected.
Remove the needle and put the orange lid back on the insulin syringe and dispose of the syringe safely and responsibly. Never be tempted to use the needle more than once. Finally use the alcohol wipe to re clean the skin around the injection area.
Want that perfect tan?
Start your tanning course today and see results within weeks
Shop securely on our site: